廠家:夜涩vip官网 | 產品名稱:天然真石漆 | 功能:裝飾 | 用途:建築牆麵 |
幹燥時間:24小時 | 特色服務:施工技術指導 | 保質期:12個月 | 產地:四川德陽 |
施工方式及步驟
1、滾塗底溱及封底處理被噴物須噴塗或滾塗配套底漆,防止牆體基層堿性物質因吸水而析出表麵,同時阻止外部水份侵入,增強麵層塗料和基層的粘附力。
1、 the primer and back treatmentBy spraying shall be sprayed or roller coating primer,to prevent the wall base alkaline material from the water surlace of two precipitation,at the sametime block extemal moisture intrusion,enhanced adhesion surface coating and base.
2、放樣標線
先用直尺或標線做出基準點,然後彈線。
2、 lfting marking
First use the ruler or markings make reference point,then the line.
3、貼線條膠帶
貼膠帶必須先貼直線,再貼橫線,對有接頭處,可釘上鐵釘,以免噴塗後找不到膠帶源頭。
3 、line tape affixed
Tape must be affixed to a straight line,then paste line,the joint,it can nail onthe nail,in order to avoid spraying after cannot find the tape source.
4、噴塗主材
用專用噴槍噴塗,通常第- -遍采用噴塗方法,24小時後噴塗第二遍,采用厚噴塗方法,噴塗氣壓力為3- -5kg,噴槍口徑為6- -8毫米。
4、 spraying material
Spraying with a special spray gun,usually the first by spraying method,24 hours after spraying second times,the thick coating method,spray gas pressure is 3- -5kg,the gun bore is 6- -8 mm.
5、去除線條膠帶
嘖塗後隨即去除膠帶,膠帶去除必須小心,不得影響塗膜切角,去除方法,盡量往,上拉開,不要往前拉。
5、 remove the lines tape
After spraying, immediately remove adhesive tape,tape removal must be careful,shall not affect the film cutting angle,removing method,Try toopen,Don't pull forward.
6、研磨.
在噴塗罩麵麵漆前,先將表麵的浮沙及鬆散顆粒鏟除,可增加麵層的手感及避開灰塵積留。
6、 grinding
In the spraying cover face paint,the surface of the sand and granulareradication, can increase the surface layer handle and avoid dust accumulation.
7、塗罩光麵漆.
待漆膜完全硬化幹燥後,可全麵塗透明罩麵漆。
7、coated topcoat
To be completely hardened dry film, to be fully coated with transparent finish.
8、成品牆麵
使用真石漆的最終效果
8、the finished wall
The final effect of lacquer。
注意事項:
1、四川乳膠漆廠家提醒本產品應在保質期內使用若超期使用.本廠將不對其品質負責,不對由此造成的任何損失承擔責任。
2、運輸為非危險品。
地址:德陽市廣漢市小漢鎮小南村五社
電話熱線:15928928761
暫無評價信息!